|
Dakota Confidence
Arrow Holder No. 005 |
Price: $21.95
each
plus shipping and handling |
To Order Call:
605-256-2373 |
|
Features:
- Prevents arrow from fall-off.
Bow can be turned in any direction (even upside down) without
arrow falling off the rest.
- Nock arrows quickly and quietly
without interference from holder or rest.
- Quiet and does not affect
arrow flight.
- Adjustable release travel
and tension.
- Fits both right- and left-hand
rests.
Compatible
With:
- Champion Pro Hunter 100, 200
and 300 arrow rests
- Golden Key Tough Man arrow
rests
- PSE Mongoose arrow rest
- Scout Mountain Turbo Launch
arrow rest
- Tiger Tuff arrow rests with
D'Longhorn or Big Claw launchers
|
 |
 |
Instructions:
- With the arrow holder slide
pin up or on top, attach the arrow holder to the arrow rest by
pushing the arrow holder clamp over the arrow rest shaft, between
the prongs. Adjust the angle of the slide pin to run approximately
parallel to the arrow shaft. Lock in place with the 6-32 x 9/16"
hex cap screw, inserted up from the bottom of the clamp and tighten
securely (BUT DO NOT OVER TIGHTEN).
- Nock an arrow, loop tubing
over arrow and push eyelet down on the slide pin.
- Check eyelet release and tubing
tension by pulling bowstring until eyelet disengages from slide
pin.
- Tubing tension or eyelet release
can be adjusted by decreasing or increasing the length of the
tubing from the back of the mounting bracket to the center of
the eyelet. When adjusting tubing length, pull tubing through
only one hole at a time.
- Arrow holder is properly adjusted
when the minimum amount of tubing tension holds the arrow on
the rest while turning the bow upside-down or in any position.
|
Product
Guide | Contact Us | Refer
this page to a friend
© 2002 Dakota Archery Products, Inc. All rights Reserved.
Patents Pending. Prices subject to change without notice. All
duties, tariffs, etc. are the responsibility of the purchaser.
Site design and maintenance by Artvertise. |
