|
Dakota Confidence
Arrow Holder No. 007 |
Price: $19.95
each
plus shipping and handling |
To Order Call:
605-256-2373 |
|
Features:
- Prevents arrow from fall-off.
Bow can be turned in any direction (even upside down) without
arrow falling off the rest.
- Nock arrows quickly and quietly
without interference from holder or rest.
- Quiet and does not affect
arrow flight.
- Adjustable release travel
and tension.
- Fits both right- and left-hand
rests.
Compatible
With:
- Montana Black Gold Trap Door
drop-away arrow rest
|
 |
 |
Instructions:
- Attach the arrow holder to
the bottom of the arrow rest launcher block with the 6-32 x 9/16"
hex cap screws and nuts, replacing the 1/2" button head
screws in the block. If you replace one screw at a time in the
launcher block, it isn't necessary to readjust the rest after
installing the arrow holder. The angle of the slide pin may need
to be adjusted slightly depending on which holes are used to
attach the launcher to the block. Adjust the angle of the slide
pin to run approximately parallel to the arrow shaft by bending
with a pliers.
- Nock an arrow, loop tubing
over arrow and push eyelet down on the slide pin.
- Check eyelet release and tubing
tension by pulling bowstring until eyelet disengages from slide
pin.
- Tubing tension or eyelet release
can be adjusted by decreasing or increasing the length of the
tubing from the back of the mounting bracket to the center of
the eyelet. When adjusting tubing length, pull tubing through
only one hole at a time.
- Arrow holder is properly adjusted
when the minimum amount of tubing tension holds the arrow on
the rest while turning the bow upside-down or in any position.
|
Product
Guide | Contact Us | Refer
this page to a friend
© 2002 Dakota Archery Products, Inc. All rights Reserved.
Patents Pending. Prices subject to change without notice. All
duties, tariffs, etc. are the responsibility of the purchaser.
Site design and maintenance by Artvertise. |
