 |
|
Dakota Confidence
Arrow Holders
 Dakota
Archery Products, Inc. has developed some new and innovative
products for bowhunters and 3-D shooters that will enable you
to experience the advantage of being able to concentrate on your
shot and "Hunt with Confidence." Arrow fall-off with
shoot-through and some drop away arrow rests happens quite often
in bowhunting conditions, whether it is while still hunting,
in a tree stand, or from a ground blind. The patent pending Dakota
Confidence Arrow Holder prevents arrow fall-off on most shoot-through
and some drop away arrow rests and is presently available in
eight different models. (No. 001, No. 002, No. 003,
No. 004, No. 005,
No. 007, No. 008,
No. 015)
The Dakota Confidence Arrow Holder has the following advantages:
- Prevents arrow from fall-off.
Bow can be turned in any direction (even upside down) without
arrow falling off the rest
- Nock arrows quickly and quietly
without interference from holder or rest.
- Quiet and does not affect
arrow flight.
- Adjustable release travel
and tension, and holder releases when you start your draw.
- Fits both right- and left-hand
rests.
|
|
Replacement
Tubing for Dakota Confidence Arrow Holders No. 009 |
Price: $2.95
each
plus shipping and handling |
To Order Call:
605-256-2373 |
|
Instructions:
- Insert angled end of tubing
through the first tension adjustment hole from the backside.
Pull the tubing through hole until the center of the eyelet is
approximately 2 1/2 to 2 3/4" from the back of the mounting
bracket.
- Insert angled end of tubing
through the second tension hole from the frontside and pull until
snug.
- Nock an arrow, loop tubing
over arrow and push eyelet down on the slide pin.
- Check eyelet release and tubing
tension by pulling bowstring until eyelet disengages from slide
pin.
- Tubing tension or eyelet release
can be adjusted by decreasing or increasing the length of the
tubing from the back of the mounting bracket to the center of
the eyelet. When adjusting tubing length, pull tubing through
only one hole at a time.
- Arrow holder is properly adjusted
when the minimum amount of tubing tension holds the arrow on
the rest while turning the bow upside-down or in any position.
- Cut off any exess tubing leaving
approximately 3/4 of an inch from the back of the arrow holder.
|
 |
|
Dakota Confidence
Arrow Holders - Compatibility Chart |
|
Your Arrow Rest
(Makes and Models) |
Dakota Confidence
Arrow Holder Part No. |
| Bodoodle
Bullet, Pro-Lite, Conquest I, Conquest II, Timberdoodle, HP Timberdoodle,
TAR200 Timberdoodle arrow rests |
No.
003 |
| Champion
Pro Hunter 100, 200 and 300 arrow rests |
No.
005 |
| Cobra
Sonic, Super Sonic and Frontiersman arrow rests |
No.
004 |
| Golden
Key 3-D Rover, 3-D Silent Rover and Platinum Premier arrow rests |
No.
002 |
| Golden
Key Speed Set Hunter (formerly EZ-Tune 100), Speed Set Rest,
Infiniti, Golden Premier and TM Hunter style arrow rests with
or without groove cut between launchers |
No.
004 |
| Golden
Key Tough Man arrow rests |
No.
005 |
| HHA
1500 Series, HHA TP Series and HHA Optiflite arrow rests |
No.
004 |
| HHA
Optitune 200, 400 and TL-3 arrow rests |
No.
001 |
| HHA
Techniglide TL-1 and TL-2 arrow rests |
No.
003 |
| Mathews
Micro-Rest |
No.
002 |
| Montana
Black Gold Trap Door drop-away arrow rest |
No.
007 |
| New
Archery Products QuikTune 800, 1000 and 3000 arrow rests |
No.
001 |
| PSE
Mongoose arrow rest |
No.
005 |
| Schaffer
MAT-1 arrow rest |
No.
008 |
| Scout Mountain
Magna Launch arrow rest |
No.
015 |
| Scout Mountain
Turbo Launch arrow rest |
No.
005 |
| Tiger Tuff arrow
rests with D'Longhorn or Big Claw launchers |
No.
005 |
| QUICKTUNE®
is a registered trademark of New Archery Products; MATHEWS™
is a trademark of Mathews, Inc.; SPEED SET HUNTER™ , SPEED
SET REST™, INFINITI™, GOLDEN PREMIER™, TOUGH MAN™
and TM HUNTER™ are trademarks of Golden Key Futura; TRAP
DOOR™ is a trademark of Montana Black Gold; D'LONGHORN™
is a trademark of Tiger Tuff, Inc.; BIG CLAW® is a registered
trademark of Tiger Tuff, Inc.; MAGNA LAUNCH™ and TURBO LAUNCH™
are trademarks of Scout Mountain Equipment; BODDOODLE™ is
a trademark of Bodoodle, Inc.; COBRA® is a registered trademark
of Cobra Manufacturing Co., Inc. |
Product
Guide | Contact Us | Refer
this page to a friend
© 2002 Dakota Archery Products, Inc. All rights Reserved.
Patents Pending. Prices subject to change without notice. All
duties, tariffs, etc. are the responsibility of the purchaser.
Site design and maintenance by Artvertise. |
|